Flange range
Pipe flanges only, no other fittings. Every type from ½" to 24" NB, to all major standards, in carbon, low-temperature carbon, high-yield carbon and alloy steels.
Every bolt hole in its place.
Choose a type for its sizes, standards and dimensions. [CONFIRM: every type in the range]
Weld neck
Tapered hub, butt-welded to the pipe. For high pressure, high temperature and cyclic service.
Slip-on
Slides over the pipe and is fillet-welded inside and out. For lower-pressure lines.
Socket weld
The pipe sits in a socket and is fillet-welded outside. For small-bore, high-pressure lines.
Threaded
Screws onto NPT or BSP threaded pipe, with no welding.
Blind
Closes off a pipe end, valve or vessel opening, and comes off for inspection.
Lap joint
Turns freely on a stub end, for lines that are often taken apart.
Long weld neck
A weld neck with an extended neck, used as a nozzle on vessels and columns.
Plate
A flat plate welded to the pipe. For low-pressure water and utility lines.
Reducing
Its bore is smaller than its nominal size, to join pipes of different diameters.
Orifice
Fitted with pressure tappings and used in pairs with an orifice plate to measure flow.
Spectacle blind
A figure-8 plate that isolates or opens a line.
Made to your drawing
Special flanges to customer drawing. Attach your DWG, DXF or PDF to your enquiry.